The power supply part and components part is separated, the power is divided into three parts, the general power supply part, the control power supply part and the measurement display part; Hang part is based on the actual use of hanging different modules; easy to use.
There are totally 5 modules, each module can be used independently or combines together. The installation location adjust according to the actual situation,easy to operate, easy to replace, expandable features or development new training; training content selection is typical, practical.
The control circuit and small motor can simulate the electric drive system of all kinds of machinery in the factory, and can meet the skill training requirements of maintenance electricians in terms of installation, commissioning, failure analysis and troubleshooting;
All the components are lead to the terminals, students only need to connect the wiring terminals, is conducive to the protection of components;
The Switching and Control Trainer is Electrical Training Aids. The practical operation of the electrical control circuits listed in the textbooks of "Elementary Maintenance Electrotechnical" and "Intermediate Maintenance Electrotechnical" can enable students to exercise their skills well and improve them. More Electrical Training Aids information please visit http://www.dolangeducation.com/electrical-maintenance-skill-training-series/1229.html
Specifition of the equipment
1,Input voltage: three-phase five-wire 380V ± 10% 50HZ
2, Working environment temperature range : -5 ~ 40 ℃
3, Device capacity:AC<1.5KVA
4, Dimensions: L × W × H = 1810x720x1620mm3
5, General power control, with leakage protection, when the leakage current reaches 30mA, the protection device action
6, The grid voltage instructions with 450V AC voltmeter pointer 3 units.
No comments:
Post a Comment